PIDVID

FS-PIDVID USB 2.0 High Speed Embedded Host Tester Fixture

€ 750,00

Features

  • USB-IF approved
  • All 11 USB2.0 High Speed Test Modes available
  • Ease of use test mode selection by ‘UP/ DOWN’ button
  • Test Mode gets initiated after selection by ‘ENTER’ button
  • Blinking LED indication when Test Mode is initiated
  • Operates in Bus Powered mode and Self Powered mode
  • Can be used by any brand of oscilloscope with enough bandwidth such as Rohde & Schwarz, Tektronix, Keysight / Agilent, Teledyne Lecroy, Yokogawa, …

Category:

Description

The PIDVID is used to initiate test modes on High Speed downstream ports of USB Embedded Hosts.  In order to perform USB 2.0 High Speed electrical tests a High Speed product must support test modes as defined in section 7.1.20 of the USB 2.0 specification. The test modes being initiated by the PIDVID are mandatory to be implemented and allow you to validate the High Speed electrical compliance charistics of your Embedded Host and USB On-The-Go product.
The Methode Of Implementation (MOI) to run the USB Embedded Host compliance tests can be found here at the USB.ORG. Please make sure that the Embedded Host OS is capable in entering the required test modes.

Technical Specifications

PROPERTY VALUE
Test Modes Test_SE0_NAK
Test_J
Test_K
Test_PACKET
Reserved (*)
SUSPEND RESUME
GET DEVICE DESC
GET DEVICE DESC DATA
Unknown device NOT support HNP
Unknown device support HNP
Test Device PID=0x0200
Features Can operate bus or self-powered (Vbus breakout possibilities)
Connectivity Standard USB B-Receptacle
Dimensions (W x D x H)  10mm X 82mm X 1.55mm (0.39 X 3.23 X 0.06″)
Maximum Input Voltage 5.5V

 

For measuring for example the High Speed EYE diagram.

 

Related products